Multi-family / Commercial systems
All ReWater systems operate on the same principle of capturing, filtering, and using untreated greywater immediately as it’s produced, keeping it fresh and good for plants. This design principle also results in much smaller, far less expensive systems than our competitors.
Typically, multi-family project owners add our rain harvesting option to satisfy their Low Impact Development (LID) requirements with one system, saving them even more money.
Each project has unique flows, topography, irrigation, and code requirements. All have the potential for significant water reuse, wastewater reduction, and pollution prevention values many times the cost of a ReWater system.
We sponsored the state greywater irrigation code in 1992 and have helped install ReWater’s systems in condos, apartment buildings, office buildings, barracks, and laundromats all over the state.
Call us at eight oh five 716-0104 to discuss how we can help you with your project.
Tank
The correct tank temporarily captures the greywater surge from your building without overflowing to the sewer while irrigating.
225 gallon fiberglass surge tank, grommet material, and bolt-on HD fiberglass lid with 8 SS screws (Requires a lint interceptor on the greywater source pipe prior to the tank)
750 gallon non-traffic concrete two-chamber tank with 4″ inlet and outlet and two 24” risers, two pedestrian fiberglass lids, two 12” riser rings, and two lid attachment ring
1,000 gallon traffic-rated concrete two-chamber tank, with 4” inlet and outlet, two 24” risers, two traffic-rated steel lids, two 12” riser rings.
Filter
The correct sand filter can handle your maximum irrigation flow rate.
19” filter vessel wrapped fiberglass
21” filter vessel wrapped fiberglass
23” filter vessel wrapped fiberglass
Pump
The correct pump sends water through the filter and piping to the farthest emitter on the irrigation network at the correct pressure.
120 VAC 0.5 hp high-head efficient pump
200 VAC 1 hp ultra high-head efficient pump
208 VAC 1.5 hp high-head efficient pump
230 VAC 1.5 hp high-head efficient pump
Do you plan to integrate rain into your greywater system or will your system be inspected by the City of Los Angeles or Los Angeles County?
Laundry water has a lot of lint. Are you going to be capturing laundry water with your system?
Parts
1 x BuIkhead Adapters, 2 @ 4”, 2 @ 2”, 2 @ 1/2” +$150.00
1 x 2” Discharge Pipe w/ male adapter, and sweep +$40.00
1 x 3-Way 2” Tee Valve w/ 24 VAC actuator +$525.00
1 x Filter Vessel Pipe Adapter +$89.00
1 x 1.5” Solenoid Valve nylon for backwash +$164.00
1 x 2” PVC Swing Check Valve +$65.00
1 x Float Switch w/20” Cable +$115.00
1 x 3” Backfow Valve w/ viewing port +$125.00
1 x 1.5” Solenoid Valve, nylon, for irrigation supplement +$164.00
1 x Pressure Regulator for 1.5” supplement valve +$95.00
1 x 1.5” Reduced Pressure Principle Device +$825.00
1 x Owner’s Operation & Design Manual (download) +$0.00
1 x “Nonpotable Grey Water, Do Not Drink” self-adhesive tape +$15.00
1 x 14” Plastic Ties for securing pump & foat wires, 3 +$3.00
Total
$2,375